Eurotrac T13-F, Operation Manual

Page: 81 / 81

Page 81/81
April 2021 W11 - W12S -W12F - W13F - T13F | Operation manual
ANNEX 4: Daily equipment inspection
While operators should not attempt to perform repairs, they do have the responsibility to report immediately any
problems to their supervisor, so that repairs can be made in a timely fashion by qualified maintenance personnel.
DAILY EQUIPMENT INSPECTION - W11/W12S/W13F/T13F WHEEL LOADER
Vehicle S/N: Date: ____/____/____ Operator:
[

] Good [A] Adjustments Completed [N] Needs Repairs
[ ] Check the engine oil and ensure that the level is
within operating range. [ ] Check the power steering fluid level by opening
the cap to inspect the level. Ensure that the
level is within operating range and then replace
the cap.
[ ] On water-cooled systems, inspect the coolant/
water level at the coolant surge tank. (Do not
remove the radiator cap to perform a routine
coolant level check.) [ ] Check the inflation pressure of each pneumatic
tire. Wheels require 4.5bar. Adjust tire pressure
as required.
[ ] Inspect the tire surface for damage or wear.
Remove stones from the surface and report any
damage, cracked sidewalls, limited tire tread,
or unusual wear. [ ] Make sure the headlights are working properly.
[ ] Check that other lights are working, including
the rear light, tail stop and turn signal lights, (if
the wheel load install this equipment). [ ] Ensure that the cab heater, wiper and the cab
dome light etc. are working (if the wheel load
install this equipment)
[ ] The horn should be clearly heard in noisy
environments. [ ] Ensure that all controls are working properly.
Report the faulty and do not use the equipment
until repairs have been completed.
[ ] Check the fuel level. [ ] The correct position of the driver's seat,
adjusting it to meet your requirements.