Euphonix MC Media Application Controller, Operation Manual

Page: 39 / 120

Euphonix Media Application Controller Operation Manual MC Preference Settings
39
4.3.2 Jogwheel Speed
The Jogwheel Speed adjusts the responsiveness of the Jogwheel. A setting of 10 (de-
fault) is 100%, or full speed. A setting of 1 is 10%, or slow response.
NOTE: We recommend a setting of 1–3 for Logic Pro.
4.3.3 Surface Filter Update Period
This setting modifies the interval at which the MC sends automation data back and forth
to your workstation(s). The range is 5–250 ms and the default is 42 ms. You will not
need to modify this setting unless your project has extensive automation, in which case
you may need to increase it. Be careful because setting it too low (rate too high) may
deliver incorrect automation.
4.3.4 Set MC Name
The Touchscreen also displays the name of the MC (default is Euphonix MC ), and al-
lows changing it. The MC Name is used to distinguish between surfaces in multiple-
MC configurations. To change the name, touch
Set MC Name , type the desired name,
and touch OK .
4.3.5 Fader Text Mode and Knob Text Mode
These settings control how fader and knobset scribble strips on the CM408T modules
behave when displaying text:
• Momentary Value : Displays values as they are changed, then reverts to the
name after a fixed time interval.
• Always Show Names : The name of the control is always displayed.
• Always Show Values : The value of the parameter is always displayed.
The value for fader strips is always the channel level in dB. The knobset value changes
depending on what is assigned to the knobset (EQ, dynamics, plug-in controls, etc.).
4.3.6 Soft Key Display and Operation
This setting controls the text brightness/contrast of the integrated LCDs in the Soft
Keys, and the timing of button latching, repeat delay, and repeat rate.