ETC IRIDEON, Installation And User Manual

Page: 69 / 84

Irideon Control Installation and User Manual 65
Step 14: Connect AC Power wires pulled from the ATC to the AC terminal
block on the MCP using the following pin/wire code:
Step 15: Using a small screwdriver, set the two rotary switches found on
the ATC’s contact closure station to the fixture address
assigned to the ATC. This address information should come
from the same source as the luminaire and remote station
addresses.
Step 16: Replace the ATC front panel.
Step 17: Replace the MCP front panels.
Step 18: Refer to “Power Up Procedures” on page 36.
AC POWER
INPUT
P1
NEUTRAL - WHITE (BLUE*)
LINE - BLACK (BROWN*)
GROUND - GREEN OR BARE
(GRN/YEL*)
* INTERNATIONAL
(HARMONIZED)