ETC IRIDEON, Installation And User Manual

Page: 30 / 84

26 Installation
Installation:
The Composer Lite System is a software driven control system more so
than a hardware system. In a Composer Lite Control System the only
hardware that may be installed is the Luminaire Programming Jack (LPJ).
Additionally the Composer Lite Programming Kit may be used for initial
programming, then removed from the system with the PC.
N o t e :
For installation of your luminaire(s) please follow the luminaire
installation instructions found in the luminaire owner’s manual. For
programming instructions please reference the Composer Lite Software
User’s Guide.
Luminaire Programming Jack (LPJ)
The Luminaire Programming Jack (LPJ) is a wall mount RJ45 receptacle
used for linking your PC to the luminaires.
Step 1: Mounting:
a. Use a RACO #680 single gang backbox, or equivalent.
Step 2: Remove the faceplate, exposing the RJ45 connector.
a. Connect the data using the following pin/wire code:
N o t e :
The LPJ does not have a station address.
Step 3: Using the screws provided, secure the LPJ in the junction box.
Step 4: Replace the LPJ faceplate.
Composer Lite Programming Kit (CLPK)
The Composer Lite Programming kit is used with Composer Lite systems
for programming. This kit includes:
• RS232-485 converter - for PC’s that do not have an RS485
communications card added.
• RJ45 cable assembly
• RJ45 - 5pin XLR extension cable
• DB9/DB25F adaptor, and a DB25 Power Supply
1
2
3
4
5
6
7
8
Ground
Data +
Data -
Note:
Pins 4 & 5
(Data + & Data -)
must share a
twisted pair.