Introduction
3
Safety
WARNING:
RISK OF ELECTRIC SHOCK! The light source in this luminaire is
not user-replaceable, and must be replaced only by a qualified technician.
Contact ETC Customer Support for assistance.
AVERTISSEMENT :
RISQUE DE DÉCHARGE ÉLÉCTRIQUE! La source
lumineuse de ce projecteur n'est pas remplaçable par l'utilisateur et ne doit
être remplacée seulement par un technicien qualifié. Contactez le service
client ETC pour obtenir de l’assistance.
WARNING:
Note the following safety warnings before use:
•
Use the fixture in dry locations only, where humidity does not exceed
90 percent (non-condensing).
•
Connect the fixture to a non-dimmable power source in order to avoid
damage to the fixture's internal power supply and other electrical
components. Using a dimmable power source can damage the fixture
and will void the warranty.
•
Disconnect the fixture from power and DMX and allow it to cool before
installing accessories or performing any cleaning and maintenance.
•
Only use mounting hardware that is rated for the total weight of the
fixture and accessories.
•
In addition to primary suspension, attach a safety cable (or other
approved safety device) to the fixture. Safety cables must be rated to
support ten times the fixture weight. Consult local standards to ensure
that safety cables meet all requirements. See
.
•
Check that the accessory holder is locked and that any accessory safety
cables are connected before mounting the fixture.
•
Do not operate the fixture without the lens installed.
•
Do not use this fixture with a damaged power lead. If the power lead
(cord set) is damaged, it must be replaced.
•
Do not use this fixture if the lens is deeply scratched or cracked. You
must replace the lens when it is damaged.
