ETC fos/4 Series, User Manual

Page: 9 / 32

Overview 5
Overview
Fixture
A
E
H
G
F
J
K
L
I
A
C
E
D
B
A Accessory holder: Insert accessories into the two available slots from either side of the holder,
and then lock the holder. See
Add Accessories on page 7 .
B
Cable tie: Store power cable on the yoke.
C
Yoke tilt-lock: Tilt the fixture as needed, and then turn the tilt-lock clockwise to lock the
position. If necessary, pull the tilt-lock away from the stem to adjust the tilt-lock position.
D
Adjustable yoke: Loosen the bolts, and then shift the adjustable yoke forward or backward as
needed to balance the fixture. Tighten the bolts to secure. See
Add Accessories on page 7 .
E Zoom knob: Rotate the zoom knob on either side of the fixture to adjust from spot to flood.
F
NFC (Near Field Communication) tag: Use the Set Light app to wirelessly configure the fixture,
with or without power applied to the fixture. See
Set Up Wireless Control on page 18 .
G
User interface: View the fixture status, set the DMX address and mode, or set stand-alone
options.
H
Antenna: For use when controlling the fixture using wireless DMX. See
Set Up Wireless Control
on page 18
.
I Safety cable attachment point: See Mount the Fixture on page 7 .
J
DMX In and DMX Thru connectors: Five-pin XLR connectors for DMX/RDM in and thru.
K
Power In and Power Thru connectors: powerCON
®
TRUE1 TOP connectors for power in and
thru.
L
Battery connector: Three-pin XLR connector for battery power. Connect the fixture to battery
power only when AC power is not available. Maximum fixture output may be reduced when
powered by battery.