61
Press the key SAVE to save above settings to the file 1 where the cursor is located, and rename it as
needed. If you need to call a saved test file, there are two ways:
1. Press the key
to go to the setting page and select
Save
, then select the desired file and press
the key
Loading
to call the stored test mode.
2, the E-load provides a quick call function, that is,
In
Menu
page, select the item
CONFIG-TEST SETTING-SHORTCUT CALL,
as shown in Figure 4.8,
after the shortcut call enabled, you can directly use the 0~9 number keys to call the test file in the
SAVE
.
1~9 corresponds to file No.1~9, and 0 corresponds to file No.10. At this time, the number key has only a
shortcut call function and no data input function. If you need to restore the data input function, you can
close the shortcut call. As shown below:
Figure 4.8 Shortcut Cal Setting Page
ET System electronic GmbH