OPERATION 13
Emergency-call alarm
This is the main function of the device.
When the emergency-call pushbutton is pressed, the device makes a sequence
of calls to the programmed numbers associated with the specific type of alarm.
Simultaneously:
•
a courtesy message is played back in alternation with pauses and tones
in the place where the alarm is generated (e.g. elevator car)
•
the “given alarm” indicator light turns on.
Note: the alarm for button 1 (installed in the car) is subject to the
filter input status, if enabled.
WARNING:
The filter input must be disabled during
maintenance operations of the elevator system.
How to answer an emergency call and reset
immediately the alarm
Please refer to the diagram on page 17.
¾
After answering the call, a series of tones will be heard.
¾
Dial
(“Acknowledge” code) or wait a few seconds. You listen to the
alarm identification message (“Emergency call”) followed by the elevator
identification message (which must be recorded during installation).
Note: you can listen to the messages again at any time by re-
dialling
(“Acknowledge” code).
¾
After 30 seconds an automatic connection with the handsfree is
established and you can talk to the person who called for help. You can
also establish the handsfree connection immediately, while listening to
the ID message, by dialling
(“Handsfree activation” code).
The duration of the handsfree connection is limited (programmable, 2 minutes
by default). The conversation time can be extended by entering any digit
