Press
M
to enter the overdial select/entry mode
and follow the selection mode rules to call up a stored
number from the phone list.
turns on. Press PTT
to send the overdial sequence once. If the number
needs to be transmitted again it must be selected or
entered again (this prevents unwanted numbers
from being sent the next time the PTT button is
pressed during the call).
This overdial select/entry mode remains active until
the call is dropped, cleared, or
M
is pressed. The
overdial select/entry mode can be re-entered if the
call is still active by pressing
M
.
System Radio:
The following steps are required to dial these num-
bers:
1.
Follow the procedure in Sending A Telephone In-
terconnect Call (Trunked Mode Only) to establish
a connection to the telephone system or consult the
system administrator for the procedure to access a
dial tone on the trunked or conventional system.
2.
Overdial numbers are transmitted using either
method as follows:
METHOD 1: Press and hold PTT while entering the
overdial number sequence from the key-
pad. This method sends DTMF tones dur-
ing individual, telephone interconnect.,
trunked group or conventional channel
56
Summary of Contents for EDACS PRISM HP/LPE-200
