then assigned as the priority-one or priority-two
channel, the previously assigned priority channel will
change to non-priority scanning. The priority setting
selection sequence is set and stops at priority-one;
therefore, the channel must be deleted from the scan
list by pressing
A
or
6
before the channel is
set to a previous priority setting. Any channel that is
in a system’s channel scan list will show
,
, or
for the time-out period when it is the selected
channel. One of the following messages may be
momentarily displayed:
SCAN DIS
The radio is not programmed to scan.
FIXED P1
A Priority 1 group has been pre-pro-
grammed into the radio. A new Priority 1
group cannot be selected.
FIXD LST
A fixed scan list has been pre-pro-
grammed into the radio. It is not possible
to change the list without reprogramming
the radio.
Deleting Channels From A Scan List
1.
With scan operation turned off select the desired
channel to delete from the selected conventional
system’s channel scan list.
2.
Press
A
(Scan) or
9
(System). The current
status is displayed for a time-out period.
85
Summary of Contents for EDACS PRISM HP/LPE-200
