EPSILON5 MKIV - USB Programmer - User Guide V1.05 19/09/12
54
3.6.3 Standalone Keypad Operation – step-by-step guide
The instructions below detail how to operate the programmer in
‘Standalone Mode’
using the
programmer keypad. A PC is not required while operating in
‘Standalone Mode’
.
1. Ensure that you have already uploaded a valid ‘Project Collection’ to the programmer
•
Use the EQTools – Upload Wizard to upload your
‘Project Collection’
.
or
•
Use the
‘Standalone Upload Wizard Utility’
to upload your
‘Project Collection’
(software
upgrade required)
2. Press the RED <YES> button to select the Programming Project
User instructions
Buttons
Status LED
Display
Press the <YES> button to select the
project
3. Wait for the programmer to CRC check the Programming Project
•
The programmer performs a full CRC validation check of the
entire ‘Standalone
Programming Project’
stored in the programmer
‘FLASH Memory Store’
.
•
If the check is OK, the programmer goes to step (5).
•
If the check FAILS, the programmer will flash the FAIL LED. Please try re-uploading your
Project Collection and then repeat the Standalone Mode process from the beginning.
User instructions
Buttons
Status LED
Display
Programmer will display the
BUSY
LED
while performing the Project CRC Image
Check.
4. Press the RED <YES> button again to execute the Programming Project
•
The Programming Project will now start to execute.
•
The
BUSY
LED will illuminate to denote that the programmer is active.
•
This may take a few seconds or a few minutes depending on the nature of the
‘Standalone
Programming Project’
.
•
The
‘Standalone Programming Project’
will either PASS or FAIL
User instructions
Buttons
Status LED
Display
•
The
BUSY
LED will illuminate
during the execution of the
project.
•
To abort the programming
sequence at any time, press the
<NO>
key.
