EPSILON5 MKIV - USB Programmer - User Guide V1.05 19/09/12
21
1.12 Programmer Specifications Overview
The table below details the hardware specifications for the programmer. Please refer to the stated
section for further information about any specific parameter.
#
Parameter
Description / comment
Refer
to
sect
1
Target Device
Support
See
Device Support List
.
For the latest version please see website.
2
Target Device
Programming
Interfaces
The EPSILON5-MK4 programmer supports the following
programming interfaces:
•
Atmel Low Voltage SPI
•
Atmel High Voltage SPI (+12V Vpp)
•
Atmel 8051 Boot loader ISP
•
NXP 8051 - Boot loader ISP
•
Zensys 3-wire SPI Interface
•
Atmel AVR JTAG
•
Atmel AT91SAM7 JTAG
•
NXP LPC21xx LPC ARM JTAG
•
ST STM32 – ARM JTAG
•
I2C for programming Serial
1.8
3
Operating modes
The programmer supports the following operating modes:
As standard:
•
EDS Development
Mode (PC controlled)
•
Project Upload Mode
using Upload Wizard (PC
controlled)
•
Standalone Mode
- Keypad
•
Standalone Mode
– Run Target
3.4
4
On-board FLASH
Memory Store
4 Mbits (512 k Bytes) FLASH Memory
5
Project storage in
Memory Store
1 x Standalone Programming Project
6
Keypad entry
2 x Push Button - <YES>, <NO>
7
Status LED’s
3 x Status LED’s located on the programmer:
<PASS>, <BUSY>, <FAIL>
These LED’s indicate the current status of the programmer.
8
Target Vcc
Voltage Detection
LED
•
Target Vcc LED will illuminate when Target Vcc voltage is
detected.
•
Threshold detection voltage: approx 3.1V
