EPSILON5 MKIV - USB Programmer - User Guide V1.05 19/09/12
27
2.0 Hardware Installation
2.1 Overview
This section details how to set up the programmer hardware including power supply, earthing
requirements, PC Serial Port Connection and ISP Header Selection.
The
EPSILON5-MK4
programmer is available as three different versions, each with different device
support and set up requirements. Please refer to the table below for instructions on how to set up
each version.
Programmer version
Instructions
EPSILON5-MK4(STD)
•
Supports programming of Atmel AVR devices
via the SPI interface
only.
•
Supports programming of Atmel ATtiny devices via the
‘High-voltage
Serial Programming Mode’.
•
Supports Atmel AT89S, AT89C51Rxx, AT89Sxxxx microcontrollers.
•
Supports NXP P89X51Rx2 devices
•
Supports Zensys Z-WAVE 100 / 200 / 300 series devices.
•
Please refer to section 2.2 onwards
EPSILON5-MK4 (AVR-
JTAG)
•
Dedicated programmer supporting programming of the Atmel AVR
family
via the JTAG interface only
.
•
Please refer to section 2.2 onwards
EPSILON5-MK4 (ARM)
•
Dedicated programmer supporting many ARM microcontroller devices.
•
Atmel ARM7 microcontroller family including AT91 SAM7S SAM7SE /
SAM7A / SAM7L / SAM7X / SAM7XC ARM7 families
•
NXP LPC21xx ARM7 families
•
ST STM32 ARM Cortex device families
•
Includes a special 20-way IDC connector cable for interfacing to ARM
Target Boards.
