QX5
QXFXO4/QXISDN4/QXE1T1/QXFXS24; (SW Version 6.0.x)
115
QXFXO4/QXISDN4/QXE1T1/QXFXS24 Manual II: Administrator’s Guide
Diagnostics
The
Diagnostics
page gives a possibility of running Network protocol diagnostics to verify QX gateway's connectivity and to download all system logs for
possible problems recovery.
The
Start Network Diagnostics
button is used to initiate
network diagnostics, i.e., to check the WAN link and IP
configuration, to verify gateway, DNS primary and secondary (if
configured) servers' accessibilities.
The
Start FXO Diagnostics
button (available only for QXFXO4
gateway) runs FXO diagnostic tests to determine the optimal
value for the FXO country specific regional setting (CSRS)
appropriate to your PSTN provider. Once the FXO diagnostic is
complete, the recommended value should be set manually on
the fxocfg hidden page. Setting this value may resolve echo or
poor audio quality issues on FXO lines.
The
Start ISDN Diagnostics
(available only for QXISDN4
gateway) button is used to initiate ISDN BRI low level
diagnostic. With these tests the ISDN physical link is checked
and the Frame Synchronization is verified.
Fig.II- 178: Diagnostics page
The
Start E1/T1 Diagnostics
(available only for QXE1T1 gateway) button is used to initiate E1/T1
Link Diagnostic
and
Diagnostic Loopback
. With
these tests E1/T1 physical link is checked, Frame Synchronization and Red Alarm states are verified. For successful
Link Diagnostic
, remote side should
have Line_loopback or Payload_loopback settings configured or a loopback terminator should be plugged to the QX gateway's E1/T1 port.
Diagnostic
Loopback
will be initiated if
Link Diagnostic
is failed or E1/T1 link is down.
The
Download system logs
button is used to download all logs to the local PC as a *.tar archive file. These logs can then be used by thThe field below will display the diagnostics results and the connectivity conditions. The system should be reconfigured if problems occur during the
diagnostics.
Security Diagnostics
The
Security Diagnostics
page allows running the security audit and getting the security reports. The
Start Security Audit
functional button is used for
running the security audit. The QX Security Audit is a security reporting system, which generates the warnings regarding the QX gateway's weaknesses
relative to the selected
Security Level
. The warnings may vary depending on the selected global Security Level. The Security Audit will detect the security
related configuration issues in Firewall, IDS, Call Routing and extension settings.
The output of Security Audit may look as follows:
Start security audit ...
Checking ...
Firewall ... done
Call Routing ... done
Extensions ... done
Users ... done
Settings do not correspond to selected security level.
You can view the complete report by clicking the 'Show the latest security
report' link below.
done.
Fig.II- 179: Security Diagnostics page
The
Show Security Report
link allows to display the last security audit report.
This page also contains the following useful links to adjust the system security:
