epur OAKBOT EOX 4.2 Series, User Manual

Page: 62 / 74

epur | USER’S MANUAL
www.epur.io - - | 62 | - - contact@epur.io
/!\ CAUTION/!\
Any error in dimension, with respect to the actual dimensions of the beam that
has to be machined may result in risks to the operator, machine and the
environment, in which case, the EPUR SAS Company shall not be held responsible.
7. The screen for entering the 2nd parameter (Y Section (b)) appears, with a
visual description. This dimension corresponds to the smallest width on the
beam. Enter the value in millimetres. Then press >>.
8. The screen for entering the 3rd parameter (X Tenon (c)) appears, with a
visual description. This dimension corresponds to the largest width of the
tenon. Enter the value in millimetres. Then press >>.
9. The screen for entering the 4th parameter (Y Tenon (d)) appears, with a
visual description. This dimension corresponds to the smallest width of the
tenon. Enter the value in millimetres. Then press >>.
10.The screen for entering the 5th parameter (Z Tenon (e)) appears, with a
visual description. This dimension corresponds to the length of the tenon.
Enter the value in millimetres. Then press >>.
If you are in an automatic mode configuration, entering parameters is over. You
can go straight to stage 13.
11.The screen for entering the 6th parameter (square shoulder (f)) appears,
with a visual description. This dimension corresponds to the size of the
high shoulder. Enter the value in millimetres. Then press >>.
12.The screen for entering the 7th parameter (high shoulder (g)) appears, with
a visual description. This dimension corresponds to the size of the side
shoulder. Enter the value in millimetres. Then press >>.