epur OAKBOT EOX 4.2 Series, User Manual, Page: 29 / 74

epur | USER’S MANUAL
www.epur.io - - | 29 | - - contact@epur.io
8. Measure the tool so as to configure the machine subsequently:
Using a rule or gauge, measure the distance between the chuck’s nut and the end of
the tool. The measurement must be extremely accurate (0.5 mm).
Incorrect measurement will cause machining that is non-compliant with the
dimensional specifications you entered.
9. Connect the power supply cable to the mains supply and start up the machine
again by pressing the green start button .
10. When changing the cutter and starting the spindle again, the system will propose
placing the spindle in position 0 on the Z axis in order to avoid any collision
between the cutter and the clamping system or the beam.
Following the warning, maintain pressure on the
"
Insert motor
"
button until movement
stops. Then press
"
Terminate
"
, and the cutter assembly procedure is over.
CAUTION
#1 – MACHINE
The tool will position itself to be
disassembled. Check that the clamping
jaw is entirely open. Once the system
has stopped, disconnect the machine’s
power supply before changing the tool.
After validation, the machine will
start to move.
RESPECT SAFETY RULES
CONTINUE