Epson WorkForce 1100, Service Manual

Page: 97 / 163

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision C
Disassembly And Assembly Disassembling the Printer Mechanism 97
Confidential
5. Disconnect all the cables and the FFCs from the connectors on the Relay Board.
 CN1 : Relay FFC
 CN2 : PE Sensor cable
 CN6 : PF Encoder Sensor FFC
6. Peel off the acetate tape, and disconnect all the FFCs from the connectors on the
Main Board, and release it from the groove on the ASF Assy.
7. Remove the APG Motor cable and PE Sensor cable from the ASF Assy.
8. Peel off the PF Encoder FFC secured by two pieces of double-sided adhesive tape
from the ASF Assy.
Figure 4-83. Releasing the Cables (2)
9. Remove the two C.B. M3 x 6 screws that secure the two Guide Roller LDs.
10. Gently pull the LD Roller Shaft to the rear of the printer, and remove the Guide
Roller LDs.
Figure 4-85. Removing the Guide Roller LD
Referring to Figure 4-83 , correctly route each of the cables and
FFCs.
PF Encoder
Sensor FFC PE Sensor cable
Groove
Relay Board
Main Board
Acetate tape
APG Motor cable
Double-
sided
tapes
C H E C K
P O I N T
When only removing the ASF Assy, you do not need to perform
"5.3.5 ASF Guide Roller LDs Position Adjustment (p150)" . In that
case, mark the installing positions of the Guide Roller LDs before
removing them, and make sure to align the markings when
installing the Guide Roller LDs.
Figure 4-84. Marking Position
Front
Face
17) C.B. M3x6
(8±1 kgf.cm)
Guide pin
Tab
LD Roller Shaft
Guide Roller LD
Guide Roller LD