Epson WorkForce 1100, Service Manual

Page: 88 / 163

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision C
Disassembly And Assembly Disassembling the Printer Mechanism 88
Confidential
4.4.5 Carriage Shaft / Carriage Unit
1. Remove the Printhead / CSIC Assy. (p.81)
2. Remove the CR Scale. (p.79)
3. Remove the APG Assy. (p.78)
4. Rotate the PG Cam (Right) to adjust its positions other than PG++ downside.
Figure 4-57. Adjusting the PG Cam

Attach the Label, Ink Position (parts code: 1510078) at the
position in the figure below.
Figure 4-55. Attaching the Label, Ink Position
A D J U S T M E N T
R E Q U I R E D
After replacing the Printer Mechanism, always make the required
adjustments referring to the following.

“Chapter 5 Adjustment (p.128) ”
Label, Ink Position
25 mm
1mm ± 1mm
C H E C K
P O I N T
When only removing the Carriage Shaft, you do not need to
perform
"5.3.2 PG Adjustment (p143)" . In that case, mark the
position of the rib on the Parallelism Adjust Bushing (Left/Right)
before removing them, and make sure to align the markings with
the ribs when installing them.
Figure 4-56. Marking Position
Parallelism Adjust Bushing (Left)
Mark the position of the rib
Parallelism Adjust Bushing (Right)
Mark the position of the rib
PG Cam (Right)