Epson TM-L90 series, Programming Manual

Page: 506 / 679

C O N F I D E N T I A L
Paper roll Kanji commands FS S Ver. 10.01 p. 506
■
If the horizontal or vertical motion unit is changed after setting the character spacing, the spacing
between the characters is not changed.
■
The character spacing is effective until ESC @ is executed, the printer is reset, or the power is turned off.
■
This command is used to change spacing between characters.
[Model-dependent variations] TM-J2000/J2100 , TM-T90 , TM-T88III , TM-L90 , TM-U230 , TM-U220 , TM-U210 ,
TM-U300A/B
TM-J2000/J2100 , TM-T90 , TM-T88III , TM-L90
The horizontal and vertical motion units are set by GS P .
TM-U230 , TM-U220 , TM-U210
The horizontal motion unit is approximately 0.159 mm {1/160 inch}. This is equivalent to a half dot
pitch.
TM-U300A/B
The horizontal motion unit is approximately 0.159 mm {1/160 inch}. This is equivalent to a half dot
pitch.
Program Example
PRINT #1, CHR$(&H1D);”P”;CHR$(180);CHR$(180);
PRINT #1, CHR$(&H1C);”C”; CHR$(0):
←
Select JIS code system
PRINT #1, CHR$(&H1C);”&”;
←
Specify Kanji mode
PRINT #1, CHR$(&H1C);”S”;CHR$(0);CHR$(0);
PRINT #1, CHR$(&H34);CHR$(&H41);
PRINT #1, CHR$(&H3B);CHR$(&H7A);CHR$(&HA);
PRINT #1, CHR$(&H1C);”S”;CHR$(8);CHR$(8);
PRINT #1, CHR$(&H34);CHR$(&H41);
PRINT #1, CHR$(&H3B);CHR$(&H7A);CHR$(&HA);
PRINT #1, CHR$(&H1C);”.”;
←
Cancel Kanji mode
Print Sample
←
Left- and right-side character spacing: 0
mm
←
Left- and right-side character spacing:
approx. 1.129 mm {8/180"}