Epson Stylus Photo 925, Service Manual

Page: 106 / 167

EPSON Stylus Photo 925 Revision A
Disassembly and Assembly Disassembly 106
C A U T I O N
T
When replacing the cleaner head built in the Pump unit, be
careful of the following points.
1) Do not touch the head cleaner with your bare hands. Ware
gloves or use tweezers.
2) Do not smear the head cleaner with oil or grease.
T
Install the Head Cleaner in such a position that the bent surface
faces the right side of the frame.
T
When installing the Head Cleaner, set the two square cut
portions of the Head Cleaner at the two hooks of the Ink System.
Figure 4-69. Setting the Hooks of Ink System
T
When installing a new Cap Unit, take care not to touch the seal
rubber.
T
The component parts in the Pump unit are not individually
supplied as ASP. So please replace the whole Pump unit when
replacing the Pump unit.
T
Take care not to crush or leave any stress on the ink tube
connecting the pump unit and the cap unit.
Head Cleaner
Hook & Cut Portion
T
When installing the Cap Unit on the Ink System Frame, insert
the ink tube into the Cap Unit properly and pass the ink tube
through as shown below.
Figure 4-70. Installing the Cap unit
Ink Tube