Epson STYLUS COLOR 580, Service Manual

Page: 81 / 149

EPSON Stylus COLOR 580 Revision A
Disassembly and Assembly Disassembly 81
4.2.6 PF motor removal
1. Remove the Housing from the printer. (Section 4.2.1 Housing removal)
2. Remove the Waste drain ink pad unit from the printer. (Section 4.2.5 Waste drain
ink pad unit removal)
3. Remove two screws (C.B.S. 3x6,F/Zn screw) securing the PF motor to the Ink
system frame.
Figure 4-20. Removing two screws securing the PF motor
4. Disconnect the connector cable for PF motor from CN3 on the Main board and
take the cable off from the hook on the Waste drain ink pad.
(On the C379Main- C board, the PF motor cable will be soldered on the Main
board directly. So, in this case, take off the PF motor cable on the Main board by
removing the solder by hearing it with the soldering iron.)
5. Remove the PF motor from the right frame.
C H E C K
P O I N T
Be sure that the PF motor cable is placed to the backward. Refer to
the Figure 4-20.
C.B.S 3x6 F/Zn screws
CR motor
n
Since the CN 3 is not located near the rear edge of the Main
board, it is easier to use the tweezers or pincers to connect the
cable to the CN3.
n
Tightening torque for screw
• C.B.S. 3x6 F/Zn screw for PF motor : 9+/1 kgf.cm
n
If the Main board dose not have CN3 for the PF motor connector
such as C378 Main-C, solder the ASP CN3 on the Main board
and connect the PF motor cable connector to the CN3.