Epson STYLUS COLOR 580, Service Manual

Page: 74 / 149

EPSON Stylus COLOR 580 Revision A
Disassembly and Assembly Disassembly 74
4.2.3 CR motor removal
1. Remove the Housing from the printer. (Section 4.2.1 Housing removal)
2. Move the CR unit from the CR home position to around the center position.
3. Push the CR motor from the right to left to slack the CR timing belt.
4. Take off the CR timing belt from the Pinion gear of the CR motor.
Figure 4-8. Taking off the CR timing belt.
5. Remove the Compression spring 15.7 and Holder reinforcement plate between the
CR motor holder and the protrusion on the Main frame with the tweezers.
Figure 4-9. Remove the Compression spring 15.7Compression spring 15.7
6. Slide the CR motor holder along with the CR motor to the left side
7. Remove the CR motor from the Printer mechanism taking the following step:
- Slide the CR motor to right side. (Step2)
- Slide the CR motor to backward to take off the fixing part placing the right side
of
the CR motor. (Step3)
- Slide the CR motor to the left side to take off the fixing part placing the left side
of
the fixing part. (Step 4).
Figure 4-10. Removing the CR motor
8. Take the CR motor’s cable out from the cable hook in the Waste drain ink pad
unit.
9. Disconnect the CR motor connector cable from the CN2 on the Main board with
tweezers.
Step 1
Step 2
CR Timing belt
Compression spring 15.7
Holder Reinforcement Plate
A D J U S T M E N T
R E Q U I R E D
n
The Gap adjustment (Bi-d adjustment) is required when the CR
motor is removed or replaced. Refer to Page116.
1
2
3
4