Epson STYLUS COLOR 580, Service Manual

Page: 80 / 149

EPSON Stylus COLOR 580 Revision A
Disassembly and Assembly Disassembly 80
4.2.5 Waste drain ink pad unit removal
1. Remove the Housing from the printer. (Section 4.2.1 Housing removal)
2. Remove one screw (C.B.P TITE 3x8 F/Zn screw) on the front right side of the
printer. (viewed from front side)
Figure 4-17. Removing one screw securing the Waste ink pad unit
3. Remove one screw (C.B.P. TITE 3x8 F/Zn screw) and take three cables off from
the cable hook in the Waste drain ink pad unit as shown in the following figure.
Figure 4-18. Removing one screws & cables at the back side of the printer
4. Remove the Waste drain ink pad unit from the printer
.
Figure 4-19. Drain ink tube setting position
C.B.T TITE 3x8 F/Zn screw
Cable holder
C.B.S. TITE 3X8 F/Zn screw
Peel off the adhesive tape
C H E C K
P O I N T
n
After assembling the Waste drain ink pad unit, be sure to set the
following three cables in the cable hook in the Waste drain ink
pad unit. Refer to the
Figure 4-18.
n
When assembling the Waste drain ink pad unit, be sure to set the
tip of the waste ink tube in the suitable position of the Waste
drain ink pad. Refer to the Figure 4-19
A D J U S T M E N T
R E Q U I R E D
When the Waste drain ink pad is replaced with a new one,
following service item is required.
n
Waste drain ink counter reset operation. Refer to Page117.
n
Tightening torque for screw
• C.B.P. TITE 3x8 screw for Waste drain ink pad unit: 9+/1 kgf.cm
Pump unit
Waste drain ink pad
Ink tube