Epson STYLUS COLOR 580, Service Manual

Page: 90 / 149

EPSON Stylus COLOR 580 Revision A
Disassembly and Assembly Disassembly 90
A D J U S T M E N T
R E Q U I R E D
n
When you replace the Frame front, make sure to lubricate the
specific amount of G26 to the Frame front. Refer to the Chapter
6 Figure6-8.
n
When you replace the Paper eject roller with new one, make sure
to lubricate the specific amount of G26 to the Spur gear 15, EJ.
Refer to the Chapter 6 Figure6-10.
n
Assemble the Paper eject roller in the following procedure.
1. Set the Spur Gear 15, EJ to the cut out hole in the Main frame.
2. Set the narrow portions of the shaft in the Paper eject roller to the
shaft guide holders on the Front paper guide.
3. Slide the Paper eject roller to the right side carefully and engage the
gear with the Combination gear 12.6, 18.4 and the Spur gear 34.2.
n
When you assemble the Front frame to the Printer mechanism,
set the CR unit to the left side and assemble the Front frame
from the right side. Be careful not damage the CR lock lever.
n
Fasten the Front frame with C.B.S. Screw 3x6, F/Zn in the order
of 1,2,3.
n
Tightening torque for screw
• C.B.S. 3x6 F/Zn screw for Front frame: 9+/-1 kgf.cm
• C.B.S. 3x5 F/Uc screw for Front frame: 9+/-1 kgf.cm
1
2
3