Epson SC-B7000 Series, Service Manual

Page: 24 / 144

SC-F7000 Serie/SC-B7000 Series Revision A
PRODUCT DESCRIPTION Control Panel 24
Confidential
Printer Setup
Side Margin (Right) 3 to 25 mm
Sets the side margin from the media’s right end while the media is set in the
printer. The media’s right end differs depending on [Media End Check]
setting in the Setup Menu as follows.
When Media End Check is On: Right end of the media
When Media End Check is Off: Right end standard position (the position up
to Platen through the center of the media set position attached on the Pre
Heater)
Side Margin (Left) 3 to 25 mm
Sets the side margin from the media left end while the media is set in the
printer. The media left end differs depending on [Media End Check] setting in
the Setup Menu as follows.
When Media End Check is On: Left end of the media
When Media End Check is Off: The position to the left 64 inch from the right
end standard position
Print Start Position 0 to 800 mm
Make this setting for printing more to the left than the setting value of [Side
Margin (Right)]. Such as when printing near the center of the media width.
The margin is a value from the media’s right end to the value set in [Print Start
Position]. When [Side Margin (Right)] is set already, the margin is the value
set in [Side Margin (Right)] plus the first value. The media’s right end
depends on [Media End Check] setting in the Setup Menu as follows.
When Media End Check is On: Right end of the media
When Media End Check is Off: Right end standard position (the position up
to Platen through the center of the media set position attached on the Pre
Heater)
Media Size Check
On Selects [On] to detect the media width and the top or [Off] to set it to off.
Select [Off] and print when Media Size error is displayed even though the
media is set correctly. However, when this setting is set to [Off], the printed
data can be out of range of the media. If it happens, the ink contaminates the
inside of the printer. Setting to [On] is recommended usually.
Off
Media End Check
On Selects [On] to detect the media end or [Off] to set it to off. Select [Off] and
print when Media Out error is displayed even though the media is set
correctly. Setting to [On] is recommended usually.
Off
Media Skew Check
On Selects [On] to stop printing and display an error on the control panel screen
when the set media is skewed, or [Off] to continue to print. The skewed media
causes media jam, so setting to [On] is recommended usually.
Off
Table 1-15. Setup Menu
Menu Menu Item/Setting Values (shaded one is the default) Explanation