Epson SC-B7000 Series, Service Manual

Page: 75 / 144

SC-F7000 Serie/SC-B7000 Series Revision A
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 75
Confidential
14. Remove the screw that secures the joint.
C) Silver M3x6 screw with built-in washer: 1 pcs
15. Remove the two screws, and separate the upper joint and lower joint.
D) Silver M3x10 screw: 2 pcs
.
Figure 3-33. Removing the Joint
16. Disconnect the FFC from the rear of the Ink Holder.
17. Remove the four screws that secure the Ink Holder.
E) Silver M4x10 S-tite screw with built-in washer: 4 pcs
18. Remove the Ink Holder pulling out the Ink Tubes and cables.
C A U T I O N
„ When the joint is removed in the next step, ink may drip off
from the tube. Prepare a waste cloth or the like in advance and
be careful not to contaminate the surroundings.
„ When removing/attaching the screw that secures the joint, hold
the mounting plate with your hand during the work to prevent
the plate from being deformed. If the plate becomes deformed,
flatten it as it was.
C
D
D
Joint
Mounting plate
C H E C K
P O I N T
For removing the screw indicated with a red circle in Figure3-34 ,
use a stubby screwdriver or insert a driver through the hole on the
Power Supply Box.
C A U T I O N
At the next step, be sure to remove the Ink Holder slowly and
carefully not to damage the Ink Tubes and cables with the sharp
metal edges of frames.
When installing the Ink Holder, pay attention to the followings.
„ Do not fold the ink tubes.
„ Be careful not to let the ink tubes and the cable get caught
between the Ink Holder and the frame of main body.