Epson PowerLite 400W, User Manual

Page: 98 / 120

98
Monitoring the Projector Over a Network
■ Address 1/2/3 Setting
Choose one of the
Address
numbers, then enter the e-mail
address where you want to receive a message when a problem
occurs and select the condition under which you want to
receive a message.
4. When you’re done, press
Menu
to exit the menu system.
When a problem occurs, an e-mail message is sent to the specified
addresses with the subject line
EPSON Projector
and the following
information:
■
Line 1: The name of the projector where the problem has
occurred
■
Line 2: The IP address of the projector where the problem has
occurred
■
Line 3: Details of the problem
Using EMP Monitor
EMP Monitor lets you use a remote computer to manage your
projectors. It lets you easily turn the projector on or off, switch image
sources, and check its status.
Before using EMP Monitor, make sure you’ve installed the software
(available for Windows only) as described on page 94. The computer
you’re using to monitor the projector should already be connected to
your network.
Opening and Closing EMP Monitor
To start EMP Monitor, click
Start > Programs
or
All Programs >
EPSON Projector > EMP Monitor
.
If you’ve added the program to the Startup programs folder, it may
already be open. If so, click the icon in the system tray on the
lower-right corner of your screen to start EMP Monitor:
note
If a critical problem develops
with a projector which
causes it to suddenly stop
working, it may not be
possible for the projector to
send a message.
If Standby Mode is set to
Network On in the
Extended menu, the
projector can still be
monitored even if the
projector is in standby mode
(when the power is off).
note
If you want to monitor the
projector while it is in
standby mode, select
Standby Mode
in the
Extended menu, then select
Network On
. See page 62.
Click here to start
EMP Monitor