Epson EPL-9000, Service Manual

Page: 94 / 162

Service Manual
Disassembly and Assembly
3.2.2.5 Low Voltage Supply Unit Unit) Removal
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
Remove the rear cover. (Refer to Section 3.2.1.1.)
Remove the top cover. (Refer to Section 3.2.1.2.)
Remove the left cover. (Refer to Section 3.2.1.3.)
Remove the right cover. (Refer to Section 3.2.1.4.)
Remove the ELEC cover. (Refer to Section 3.2.2.1.)
Disconnect the connector
board.
6, on the
Remove 3 screws
x 6)
securing the box, and remove it and the board.
Remove the fusing unit. (Refer to Section 3.2.5.1.)
Figure 3-10. Removing the
Box
Remove 1 CB screw x 6) securing the earth wire of the HVPS board to the unit.
Remove 2 CBB screws x 10) securing the ROS unit, and remove connector P101 of the
fusing unit.
Remove 2 CB screws
x 6) and CBS(0) screw x 6) securing the unit, and
remove it.
Remove the saddle edge H from the
unit.
Figure 3-11. Removing the Unit
Rev.
3-9