Installation
8
VGA2Ethernet User Guide
Figure 4.
Composite video to DVI converter (not included)
Table 1: Connector, Interface and LED Descriptions
ETH1
Primary 10/100/1000 Base-T RJ-45 auto-sensing Ethernet
network port to connect the VGA2Ethernet device to an
Ethernet network. The VGA2Ethernet device Ethernet port is
auto-sensing.
ETH2
Secondary 10/100/1000 Base-T RJ-45 auto-sensing Ethernet
network port. This port is useful in case you need to configure
the Ethernet Bridge when there is only one Ethernet
connection. See Configuring the Ethernet Bridge For Use if
You Have Only One Ethernet Connection.
Power
Connect the AC adapter to the VGA2Ethernet power
connector and to a power outlet
LEDs
Red LED: during operation the red LED blinks each time the
VGA2Ethernet captures an image. You can use the red LED
as an indicator that the VGA2Ethernet is capturing images.
Green and blue LEDs: when the VGA2Ethernet device first
starts up, the blue LED lights up. A few seconds later the
green LED lights up. After about another 20 seconds the blue