1. Installation and Getting Started
Connect and Power on a Lecture Recorder Device
Page 16
VGA Recorder
Figure 10:Connecting to the Ethernet network and connecting
power
The Lecture Recorder device powers on and the LEDs go
through their power on sequence:
• When power is first connected the blue LED lights up.
• A few seconds later the green LED lights up.
• After about 20 seconds the blue LED turns off, leaving the
green LED on to indicate that Lecture Recorder device has
started up and can start recording images.
6
Start up the video source.
To confirm that the Lecture Recorder Lite device is receiving
images from the video source:
• Log into the VGA Recorder Web admin interface (see
“Connecting to the VGA Recorder Web admin interface”
on page 25
) and confirm that a file is shown as recording.
• Under System Status select
Start
. If you cannot select Start,
the VGA Recorder is already recording.
• Select Preview to view the recorded image.
• Check to see if the Lecture Recorder red LED is blinking
indicating that device is recording images.
• If you connected a monitor to the OUTPUT port, check to
see if it displaying video.
If the red LED does not start flashing, and the monitor
connected to the OUTPUT port does not show an image, check
the video source to make sure it is transmitting a video image.
Also check the cable between the Lecture Recorder device and
the video source to make sure it is connected correctly.
Eth 1
Power Input
