1. Installation and Getting Started
Connect and Power on a VGA Recorder Lite Device
Install Guide
Page 13
The VGA Recorder Lite device powers on and the LEDs go
through their power on sequence:
• When power is first connected the blue LED lights up.
• A few seconds later the green LED lights up.
• After about 20 seconds the blue LED turns off, leaving the
green LED on to indicate that VGA Recorder device has
started up and can start recording images.
4
Start up the VGA source.
The Red LED should start flashing indicating that the VGA
Recorder Lite device is recording images.
To confirm that the VGA Recorder Lite device is receiving
images from the VGA source:
• Check to see if the VGA Recorder Lite red LED is blinking
indicating that device is recording images.
If the red LED does not start flashing check the VGA source to
make sure it is transmitting a VGA image. Also check the cable
between the VGA Recorder Lite device and the VGA source to
make sure it is connected correctly. You can also connect a
monitor to VGA OUT to check for the presence of a signal.
5
Log into the VGA Recorder Web admin interface
See
“Connecting to the VGA Recorder Web admin interface”
on page 25
.
