VGADVI Broadcaster User Guide
5-3 File and Recording Transfer
instead of the IP address.
3. Specify the
Server Port
used for the target FTP server. The standard port is 21.
4. Enter the FTP account username in the
Login
field.
5. Enter the FTP account password in the
Password
field; the characters are masked with dots.
6. Select Use temp file to name files with a temporary filename extension (.part) on the server until upload
is complete.
7. Click
Apply
; if there are any problems the system notifies you with a message: One or more parameter
values are not valid and those were not applied!
The following table describes the options applicable to configuring upload to an FTP server.
Table 22
FTP Automatic Upload Configuration Options
Name
Description / Options
Server address
The IP address (or fully qualified domain name) of the FTP server.
Server port
The port used by the target FTP server. Standard port is 21.
Login
Username for the FTP server.
Password
Password for the FTP user.
Use temp file
Causes files to be named with .part extension on the server during active upload. When the
upload completes, the file is renamed to the appropriate extension (.mov or .avi).
Configure Automatic File Upload using RSync (Part 2 of 2)
This procedure assumes you have completed the steps in
Configure Automatic File Upload (Part 1 of 2)
and
wish to continue with configuration of upload using RSync.
To configure upload using RSync:
1. Select
RSync Client
from the protocol drop down list in the Automatic File Upload configuration page;
the lower half of the page reflects the selection.
122
