QX1000 Manual III: Extension User's Guide
Extension User’s Menus
QX1000 (SW Version 5.3.x)
39
Save
will display the error “Caller address already exists”. A wildcard is allowed in this field (see chapter
Entering SIP Addresses Correctly
). Entering
“*” as PBX address will apply configuration of Caller ID Based services to all extensions.
The extension number should be inserted into the
Forward To
text field for the PBX call type.
Send Notification Via SMS
checkbox enables SMS notifications sending to the user’s mobile phone when Unregistered/Inaccessible call forwarding
on the corresponding extension from the certain caller takes place. This checkbox selection enables the
Mobile Number
text field where the user’s
mobile phone number should be defined. If you feel this service is not working, contact your system administrator to configure the SMS Settings.
Send E-mail
checkbox enables email notifications sending to the user’s mailbox when Unregistered/Inaccessible call forwarding on the
corresponding extension from the certain caller takes place. This checkbox selection enables the
E-mail Address
text field where the user’s email
address should be defined. If you feel this service is not working, contact your system administrator to configure the Mail Settings.
When saving this call forwarding configuration, a message will notify the user that Many Extensions Ringing and Call Hunting services have been
disabled.
Find Me / Follow Me
The
Find Me / Follow Me
service of the QX1000 allows you to configure simultaneously or subsequently ringing destinations on the incoming call
from the certain caller. The ringing destinations can be local PBX extensions or remote SIP destinations. From this page you may also adjust a
sequence in which the destinations will ring.
Attention:
This service has higher priority over all Caller ID based supplementary services, except for Incoming Call Blocking and Unconditional Call
Forwarding. This means that if the same caller is configured in the incoming call blocking, unconditional call forwarding and the Find Me/Follow Me
pages, the incoming call blocking and the unconditional call forwarding services will take effect. Besides this, if you have Find Me/Follow Me service
enabled along with the Many Extensions Ringing, No Answer Call Forwarding, Busy Call Forwarding or Call Hunting, only Find Me/Follow Me service
will take effect.
The
Enable Service
checkbox selection activates the Find Me/Follow Me service on the current extension.
The table displayed here lists destinations where the incoming call from a particular caller will be ringing in the configured sequence.
The
Enable/Disable
functional buttons are used to enable
or disable ringing on the destinations in the Find Me/Follow
Me table.
The
Ring Extension Phone
drop down list is used to select
the interval in which the current extension (on which you are
currently configuring the Find Me/Follow Me service) will ring
on the incoming call from the selected caller. With the
Immediately
selection, the current extension will ring
immediately as the call comes in.
The
Max Active Calls Count
text field requires the
maximum number of active calls.
If
N= 1
, where
N
is the maximum number of active calls,
then only one active call will be possible to make and the
next call will go to the voice mail. If
N
>1, then the next call
will go to the next Find Me/Follow Me phones (if configured)
which are not in the call.
The
Confirmation Passcode
text field requires the
password to accept the call for destinations where passcode
activation is enabled (see below). Only digit values are
allowed in this text field.
Fig. III-34 Find Me/Follow Me page
