QX1000 Manual III: Extension User's Guide
Extension User’s Menus
QX1000 (SW Version 5.3.x)
32
6.
If the reconfiguration of
Caller ID Based Services
is needed, click on the corresponding
Address
in the
Caller ID Based Services
table to
open the
Caller ID Based Services for Address
page.
7.
From the left frame, choose a Caller ID Based Services. From the right frame, change the corresponding service settings, if required.
Remember to
Save
the configurations each time moving between the Caller ID Based Services configuration pages.
Hiding Caller Information
The
Hiding Caller Information
service is used to hide QX1000 user information depending on the called destinations. When this service is
activated,
Unknown
or
Anonymous
(or similar text, depending on the type of the phone) will be displayed on the called phone when the current
user of QX1000 makes outgoing calls to the selected destination.
Attention:
Using the “Block Last Caller” operation from the handset for the caller with the hidden caller ID (for example, anonymous@anonymous or
similar) may block all unknown callers.
The
Enable Service
checkbox selection hides the current
extension’s information when calling to the corresponding
Address
listed in the Caller ID Based Services table.
Please Note:
Even if the
Hiding Caller Information
service is
enabled, it shall work only for internal PBX calls and SIP calls. If
you call through FXO/ISDN port to a PSTN number, the called
party will still see your caller ID. To hide your caller ID for PSTN
destinations, contact your PSTN operator.
Fig. III-22 Hiding Caller Information page
Incoming Call Blocking
Incoming Call Blocking
allows blocking unwanted incoming calls for a QX1000 extension. This page provides the necessary settings for incoming
call blocking. It indicates if the service is enabled for the particular caller and whether or not the custom message will be used to inform the caller
about the call being blocked. If the service for the particular caller has been enabled by the administrator and has been stated as protected, the user
cannot disable it.
Please Note:
The administrator can protect the service from being disabled by you. Contact the administrator if callers complain that they cannot
reach you.
The
Enable Service
checkbox selection blocks all calls to the current extension using the corresponding
Address
listed in the Caller ID Based
Services table where the Incoming Call Blocking service is configured.
The
Send Message to Caller Party
checkbox is available when the service is enabled and initiates a message to inform the caller that their line has
been blocked. Otherwise, the calling party will be disconnected without notification.
The
Restore Default Blocking Message File
restores the default incoming call blocking message if another user-defined file has been previously
selected. When the checkbox is selected, the file upload possibility will be disabled.
