EPAK Basic Line TV44, Manual

Page: 55 / 140

You are now back in the main menu and can switch to other satellites or make adjustments
in the Setup menu by pressing the

key.
6.3 Special functions via the Standby mode
The following information can be obtained via the Standby mode: software version of
antenna unit and control unit, serial number and operating hours counter.
Please proceed as follows:
1.
Turn on the control unit. The display shows
Init
, meaning initialization is started. Wait
for the initialization to be completed, and then press the

key to enter the Standby
mode.
2. To obtain the special functions, press and hold the

key
while switching between the
following functions with the

key:
" serial number.
" operating hours counter.
" software version of the antenna unit:
VA X-XX
" software version of the control unit:
VC X-XX
3. After releasing the

key, the display returns to
Standby
.
6.4 Fastscan function (US only)
The tracking system works faster with the Fastscan function. However, if the antenna is
locked to a satellite and the TV does not show a picture, the Fastscan function can be
deactivated by following these steps:
1. Press

repeatedly until the display shows
Setup
(flashing), then press

. Enter
password, see chapter 3.4. If the password is correct you are in the Setup menu with
Tracking
on the display.
2. Press

repeatedly until
FastScan appears.
Press

to confirm.
3. Press


to switch from On to Off, and confirm with

.
4. The display now returns to
FastScan
. Press

until
quit
appears and confirm
with

. The display shows
Setup
(flashing).
You are now back in the main menu and can switch to other satellites or make adjustments
in the Setup menu by pressing the



key.
English Page 20 / 34