EPAK Basic Line TV44, Manual

Page: 54 / 140

6 Miscellaneous
6.1 Compass calibration
The calibration of the compass has to be executed in the harbour in calm waters! If the
mounting surface of the antenna unit changes, or if the superstructures in vicinity of the
antenna unit are modified, the calibration has to be done again!
Please proceed as follows:
1. To go to the Setup menu, press

repeatedly until the display shows
Setup
(flashing), then press

.
Enter password, see chapter 3.4. If the password is correct you
are in the Setup menu with
Tracking
on
the display.
2. Press


repeatedly until
CompCal
appears. Press


to confirm.
3. The display interchanges between
Compass
and
UpDate?
. Press

to calibrate.
4. The display interchanges between
Compass
and
calibrat and
then
checking
(flashing).
If the calibration was successful, complete is shown
for a brief moment.
. After that it returns to
CompCal
. If the display shows
ErrComp
, the calibration was not successful and has to be repeated. If several
attempts remain unsuccessful, there are too many ferromagnetic objects close by the
antenna causing electromagnetic disturbances.
!!
Should these objects not be displaceable, please turn off the compass for that desired
satellite position. (see chapter 5.1.5)
5. The display will return to
CompCal
. Press

to go to
quit
, and press

to
confirm. The display shows
Setup
(flashing).
You are now back in the main menu and can switch to other satellites or make adjustments
in the Setup menu by pressing the

key.
6.2 Adjustment of the LNB type
In order to change the LNB type, see the following procedure:
1. To go to the Setup menu, press

repeatedly until the display shows
Setup
(flashing), then press

.
Enter password, see chapter 3.4. If the password is correct you
are in the Setup menu with
Tracking
on the display.
2. Press

repeatedly until
LNB Type
appears. Press

to confirm
.
3.
The display will show lin 0(format) , the standard setting valid for Europe for a linear
LNB with a skew of 0°.
By pressing the

key you can change the LNB settings. Press

to confirm. The display will return to:
LNB Type
.
!!
The standard setting
lin 0 
is supported by a standard system (see chapter 3.5) The
LNB mounting plate makes a change of the skew possible. Please adjust the skew to the
respective location. Reception from circular polarized satellites will require a circular
LNB type.
4. Press

repeatedly until
quit
appears, then press

. The display shows
Setup
(flashing).
English Page 19 / 34