EPAK Basic Line TV44, Manual

Page: 48 / 140

4 TV operation
Press the

key to turn on the control unit. The display shows Init for initialization. After
the initialization is completed, the display interchanges between scanning and Sat X
(X is the last shown storage position) until the satellite has been located. The system will
now run a check on the satellite:
checking appears on the display. If o.k., the display will
briefly show complete and then return to Sat X . The antenna will maintain its
connection to the satellite even when the boat is moving. (Providing that the tracking
function is active (
On in the Setup menu), see chapter 3.5).
If you wish to select a different satellite, press

repeatedly until the desired satellite
position appears and confirm with

.
!!
If no satellites are stored, the display will show
Setup
(flashing). You are now back in
the main menu and can add new satellites (see chapter 5.1).
If the search for a new satellite takes more than 1 minute, even though there is a clear view
to the satellite, or if, after several times of finding the right satellite, the display shows
updreco
interchanging with the actual satellite number, the satellite data base has to be
updated, see chapter 5.2.
If, after the search of the satellite, the display shortly shows (complete) and afterwards (Sat
X) without a picture on the TV, there are two possibilities:
1. The satellite service provider has changed the transponders or it is the wrong satellite. In
order to proof the right satellite has been found, try to switch to other programs on the
receiver. If all other programs are in their usual places, you need to reprogram your
receiver for the program which has changed. Please refer to the manual of the receiver.
2. US only: In case no program can be received, try to turn off the Fastscan function (see
chapter 6.4).
When changes are made, return to Sat X and press  to start a new search. If the search
for a new satellite takes longer than 4 minutes and after some time the display shows Sat
ok?
, then the requested satellite could not be found. All available satellites will be
presented and the operator can choose one.
Make sure the receiver is switched to a program from the requested satellite, so the correct
satellite can be identified.
If the display shows Sat ok? and there is no picture on the TV, press  to continue
the search. This has to be repeated until the TV shows the correct picture. Press  to
confirm. The display will now interchange between Sat X and UpDate? . Press  to
update the satellite data base. The display will flash: updating , and shortly after:
checking , and then: complete . The display will now return to Sat X and the
requested program will appear on the TV. If the display interchanges between scanning
and
complete
during the search, no suitable satellite could be found.
After confirming with

you are back in the
main menu and the display will show
Setup (flashing).
Check all cable connections and make sure there is a clear view (no
obstacles) to the satellite and the receiver is correctly adjusted. Then repeat this procedure.
!!
The menu item
Upd Sat
is not shown when the tracking function is deactivated (see
English Page 13 / 34