EPAK Basic Line TV44, Manual

Page: 53 / 140

cancel, the display shows
cancel
.
6. In both cases, the display will return to
Del Sat
.
!! If no further satellites are available for deletion, the display shows
Tracking
!
If there are more satellites in the system you wish to delete, press

and repeat from point
3! If you want to leave the menu, press

until quit appears and then press

. The
display shows Setup (flashing).
You are now back in the main menu and can switch to other satellites or make adjustments
in the Setup menu by pressing the

key.
5.4 Selection of stored satellites
5.4.1 Automatic selection of satellites
For an automatic selection of satellites, the receiver must support the DiSEqC ™ function.
Furthermore, it is important that all satellites in the DiSEqC™ menu of the receiver and of
the antenna unit are stored under the same number! In case your receive does not support
DiSEqC™ please go to chapter 5.4.2.
!! Example: Satellite Astra is stored under DiSEqC" position 2 in the receiver, meaning
that this satellite has to be stored in the antenna unit under
Sat 2
.
1. Press

repeatedly until the display shows
Auto Sat (
flashing). Press

. From
now on, the antenna unit will take over the satellite positions from the receiver. The
display interchanges between
scanning
and
Sat X
, whereas X is the desired
storing position. After the satellite is located, the display will continue to show
Sat
X
. The satellite tracking system is now in TV mode.
!! If
Auto Sat
does not appear in the display, the feature is not supported by the
receiver (or not activated). The setting is DiSEqC 1..4 or similar. Refer to the user
manual of the receiver. The TV45 does not support this feature.
If the selected satellite is not stored in the antenna unit, the display interchanges between
Sat X (the selected storage position) and noData . In this case, check the receiver
parameters and store the satellite in the antenna unit, meaning that the search mode has to be
started again (see chapter 4).
You can now switch to the main menu (flashing display) by pressing the

key.
5.4.2 Manual selection of satellites
For a manual selection of satellites, see the following procedure:
1. Press

repeatedly until the display shows flashing
Sat X
, whereas X is the satellite
storage position.
2. Select between the storage positions 1 - 4 by pressing

. Confirm with

.
!! Only satellites already stored are shown.
The display interchanges between
scanning
and
Sat X
, whereas X is the desired
storage position. After the satellite is found, the display will continue to show X. The
satellite tracking system is now in TV mode.
English Page 18 / 34