EPAK Basic Line TV44, Manual

Page: 52 / 140

then the system automatically jumps to the TV mode of the just stored satellite (the
display shows
Sat X
, whereas X is the storage position). The ship can now be moved
and the reception tested. In case a failure occurs and the data is not memorized correctly,
the display shows
ErrSave
and the calibration has to be done again.
!!
For each new satellite, the search-mode must be repeated! You can store up to four
satellites.
5.2 Update of satellite data base
Example : The Astra satellite was stored in German waters. Now the vessel is sailing in
Scandinavian waters. The angles of the satellite has, therefore, moved and it takes longer to
locate the satellite. To shorten the search time, new data for the angles has to be stored:
1. To go to the Setup menu, press

repeatedly until the display shows
Setup
(flashing), then press

.
Enter password, see chapter 3.4. If the password is correct you
are in the Setup menu.
2. Press

repeatedly until
UpdSat
appears. Now the up-to-date angles can be stored by
pressing

. Please keep in mind, that the menu item
UpdSat
is not shown, if the
tracking function is deactivated (see chapter 4.1).
3. The display interchanges between
Sat X
(storage position of current satellite) and
UpDate .
4. To cancel, press

/ to confirm (if the picture quality is optimal), press

.
5. If you chose to cancel, the display shows cancel(format) for a brief moment. If you
chose confirm, the display interchanges between
updating
and
checking
.
6. After correct calibration, the display shows complete(format) for a brief moment and
the system automatically jumps to the TV mode. If the update was not successful the
display shows
ErrSave
and the system returns to the menu item
UpdSat
. In this
case, please repeat the calibration.
Next time the antenna is turned on, the angles and frequency data of the satellite are stored
for the current area. This procedure should be repeated in every other region (at a distance of
200-300 km), because the angles of the satellite move with every change of the vessel's
position.
5.3 Delete stored data
To delete stored satellite positions, the following steps must be completed:
1. To go to the Setup menu: press

repeatedly until the display shows
Setup
(flashing), then press

.
Enter password, see chapter 3.4. If the password is correct you
are in the Setup menu.
2. The display now shows
Tracking
. Press

repeatedly until
Del Sat
appears.
Press

.
!!
Del Sat
can only appears if satellites are stored in the system.
3. The display shows
Sat X
, whereas X is the first satellite storage position to be
deleted. To choose the satellite to be deleted, press

and confirm with

.
4. The display interchanges between
Sat X
and
Delete
. To confirm, press

/ to
cancel, press

.
5. If you chose confirm the display shows
complete
for a brief moment. If you chose
English Page 17 / 34