InfraStyle / InfraStyle i - Installation Instructions
39
Installation
Removing the front panel from the housing
1
NOTICE Do not drop the front panel.
Insert the removal tool in the slot at the base of the housing.
If you are mounting the housing on the wall, loosen the front panel in
the same way.
2
Carefully loosen the front panel using a consistent amount of force. Re-
move it by hand.
Mounting the housing in the wall
1
Identify the installation site.
2
Prepare a wall cut-out:
The housing is fixed with clips if the wall has a thickness of 15–30 mm.
The cut-out may not be larger than this or the clips will not be able to
hold the unit. See
3
NOTICE Do not pull at the plug when routing the control line. Doing so
could damage the line. Attach the taught wire only to the cable. Do not
pull the line too taught so that you can easily remove the control panel
at a later time.
Route the control line from the relay box to the control panel.
The smaller RJ10 plug on the connecting cable must be routed to the
control panel.
Height x width = 117 x 120 mm
Height from floor: approx. 1500 mm. The mid-point of the control
panel should be at eye level.
