Envent Engineering Ltd – 131S & 132S Software Manual – Revision 1
Page 1
1.0
Introduction
1.1
About This Manual
The 131S/132S Gas Chromatograph uses the Envent ICE software for configuration, calibration, and
reporting. To install the ICE Software, refer to the installer which comes in a USB flash drive supplied
with the analyzer. If the USB flash drive is missing or damaged, contact Envent Support for access to
the software.
This manual will cover only basic operation and configuration of the gas chromatograph. Any
advanced configuration items are not covered; if the user wishes to perform an operation not covered
in this manual, please contact Envent Support.
This manual will be referring to models 131S and 132S. However, the information applies equally to
the 131S-T4 and 132S-T4, unless otherwise stated.
1.2
Warranty and Liability Statements
Products produced and supplied by the manufacturer (Envent Engineering Ltd), unless otherwise
stated, are warranted against defects in materials and workmanship for up to 18 months from the
shipping date or up to 12 months from the start-up date (whichever comes first). During the warranty
period the manufacturer can choose to either repair or replace products which prove to be defective.
The manufacturer or its representative can provide warranty service at the buyer's facility only upon
prior agreement. In all cases, the buyer has the option of returning the product for warranty service to
a service facility designated by the manufacturer or its representative. The buyer shall prepay all
shipping charges for products returned to a service facility. The manufacturer or its representative
shall pay all shipping charges for the return of products to the buyer. The buyer may also be required
to pay round-trip travel expenses and labour charges (at prevailing labour rates) if the warranty has
been violated. The warranty may be considered violated for any of the reasons listed below.
1.2.1
Limitation of Warranty
The foregoing warranty shall not apply to defects arising from:
•
Improper or inadequate maintenance of the product by the user
•
Improper unpacking or installation procedures
•
Inadequate site preparation
•
Unauthorized modification or misuse of the product
•
Operation of the product in unfavorable environments such as at high temperatures, high
humidity, or in corrosive atmospheres
Summary of Contents for 131S
Page 2: ......
