Envent 131S, Manual

Page: 8 / 56

Envent Engineering Ltd – 131S & 132S Software Manual – Revision 1 Page 4
2.2 File Menu
File
New… Opens the new device dialogue menu
Open… Opens a saved “.device” configuration file
Chart… Opens a saved “.chart” chromatogram file
Close Closes the current configuration file
Save Saves the current configuration file to the previously defined save
location. If no save location has been defined, this will open the “Save
As…” dialogue box
Save As… Opens the Windows “Save As…” dialogue box. This is used to save a
current device file
Import Device Config… [Advanced use only] this option will allow the user to import an older
firmware configuration to a newer firmware configuration
Device Programmer… [Advanced use only] the device programmer allows the user to upload a
firmware revision to the analyzer
Printer Setup… Opens the Windows printer setup
Page Setup… Opens the Windows page setup
Exit Exits the software
2.3 View Menu
View
Preferences… Allows the user to change software preferences such as the time units,
chart preferences, and temperature/pressure units displayed
Serial Port Setup… Allows the user to adjust the timing on the serial port
Reporting… Opens a dialogue box which can adjust the various views and reports
that the software outputs
2.4 Network Menu
Network
Add New… Opens a dialogue menu for the user to add a new networked device
Scan Network Scans the currently connected sub-network for new devices
Clear Scanned List Clears the below list of previously scanned, or added, devices
[Network List] Displays a list of all the network devices the software has scanned or
added since the last time the list was cleared. Note: these devices may,
or may not, be currently connected to the network.