S-Play User Manual
Part No.: 51301
6 March 2021
(v26)
Document ID: 4686708
Page
|18
Network Discovery
To configure your S-Play you will be required to use its web interface, to find your S-Plays IP
Address you can either:
View the S-Plays LCD
1.
Ensure your S-Play is physically hooked up to your network (or WiFi router) using an
ethernet cable – DHCP is recommended for first time use.
2.
Power up the device.
3.
Monitor the LCD menu. The LCD will display the IP address in the LCD home page. If your
S-Play’s LCD shows ‘DISCONNECTED’ check even when your S-Play is set to the correct
IP setting (either Static or DHCP) and power cycle the device.
4.
Using a browser on a device within the same network range, type in the IP address
shown on the LCD in order to access the web interface to load the S-Play web interface.
All configuration can be done using the devices web page.
Finding an S-Play’s IP Address from NMU
ENTTEC provides free software (available for Windows and MacOS) called Node Management
Utility (NMU) that find the S-Play and display its IP address.
Note:
The S-Play is only supported by NMU v1.93 and above.
Please follow these steps:
1.
Download NMU from
www.enttec.com
2.
S-Play should be connected physically by an ethernet cable to the same physical
network (or router) as the computer on which you will run NMU.
3.
Open NMU. If prompted to, select your computers network interface that your S-Play is
connected to.
4.
Press the Discovery button and wait until NMU finds all supported ENTTEC devices
5.
Once found, select ‘S-Play’ and press ‘Configure’ to be directed to your S-Plays Web
interface.
Note:
When the S-Play is set to a static IP, the default gateway
MUST
be the same for both the
S-Play and your computer for NMU to discover the S-Play.
