Enterasys X-Pedition 8000/8600 Getting Started Guide
85
Installing a PCMCIA Flash Card
–
The X-Pedition will boot up and the following messages will appear, indicating that the
PCMCIA flash card was installed successfully:
–
The X-Pedition will start to boot up but stop after a few seconds, leaving the router in boot
mode. If the X-Pedition displays the “external flash card absent” message, the PCMCIA
flash card was not found and an image was not loaded. If this occurs, power off the
X-Pedition and verify that the PCMCIA flash card is properly installed (refer to steps 2 and
3). Power on the router—if the problem persists, contact Enterasys Technical Support (see
Technical Support
on page 125
).
–
The X-Pedition will start to boot up but stop after a few seconds, leaving the router in boot
mode. If the X-Pedition does not display the “external flash card absent” message, the
router did not find an image to load from the PCMCIA Flash Card. Please contact Enterasys
Technical Support for assistance (see Technical Support
on page 125
).
Note:
If you boot from a TFTP server and the system does not detect a PCMCIA card, the
“external flash card absent” message will appear. As the system firmware boots, the
%SYS-E-NOFLASHCARD message will also appear, indicating that the PCMCIA card is
not present or is not installed correctly. If this occurs, power off the X-Pedition and verify
that the PCMCIA flash card is properly installed (refer to steps 2 and 3). Power on the
router—if the problem persists, contact Enterasys Technical Support (see Technical
Support
on page 125
).
%SYS-I-FLASHCRD, Mounting 32MB Flash card
%SYS-I-FLASHMNTD, 32MB Flash card mounted
Summary of Contents for 8000/8600
Page 1: ...Getting Started Guide Revision Date 11 27 2002 8000 8600 9032552 16...
Page 8: ...vi Enterasys X Pedition 8000 8600 Getting Started Guide...
Page 116: ...104 Enterasys X Pedition 8000 8600 Getting Started Guide...
Page 142: ...Index 130 Enterasys X Pedition 8000 8600 Getting Started Guide...
