Enterasys X-Pedition 8000/8600 Getting Started Guide
71
Installing the Hardware
Installing Line Cards
You can install line modules in slots 1 to 7 on the X-Pedition 8000 (slot 0 allows a control module
only) or 1 to 15 on the X-Pedition 8600 (again, slot 0 allows a control module only). If you plan to
install a redundant control module, you may install line cards in slots 2–7 on the X-Pedition 8000
and 2–15 on the X-Pedition 8600. Before you begin, please review
Table 19
for system firmware
requirements, restrictions, and special instructions that apply to the line card you are installing.
ELECTRICAL HAZARD: Only qualified personnel should perform installation procedures.
Table 19. Line card installation notes
Minimum
Firmware
Restrictions
Special Instructions
SSR-ARE
Note: The SSR-ARE is designed for the
X-Pedition 8000/8600 only—do not try to
install these modules in any other units. Do
not install the SSR-ARE in slot 0 or 1 on the
X-Pedition 8000 or slot 0, 1, or 15 on the
X-Pedition 8600.
SSR-ATM29-02
3.0.0.0
CLI Setup
Enter the following commands at the CLI before
implementing any configurations.
1.
Enable
—>
Configuration
—>
<Enter>
.
2.
Once you reach the configuration prompt, you
can create the ATM interface using CLI
commands as described in the ATM section of
the X-Pedition CLI manual. Enter the
?
character to view the options available to you in
configuration mode.
Proper Boot sequence
•
The control module on the chassis should indicate
that the SSR-ATM29-02 was detected and is
operating correctly.
Common Errors
•
Make sure the chassis is connected to a terminal
through a console port.
Helpful CLI Commands for Debugging
•
System show hardware
•
System show version
•
System show bootlog
Summary of Contents for 8000/8600
Page 1: ...Getting Started Guide Revision Date 11 27 2002 8000 8600 9032552 16...
Page 8: ...vi Enterasys X Pedition 8000 8600 Getting Started Guide...
Page 116: ...104 Enterasys X Pedition 8000 8600 Getting Started Guide...
Page 142: ...Index 130 Enterasys X Pedition 8000 8600 Getting Started Guide...
