33
IMPORTANT!
READ AND FOLLOW
ALL
INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR
DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.
REPLACING
COMPONENTS
Auger
Motor
1.
Before
beginning
any
component
replacement,
be
certain
the
unit
is
unplugged
and
thoroughly
cooled
down.
Also,
make
sure
the
hopper
is
empty
before
attempting
to
remove
or
replace
the
auger
motor
assembly.
2.
Remove
the
back
panel
of
the
unit;
before
loosening
any
bolts,
detach
the
wiring
harness
from
the
auger
motor.
3.
Locate
the
auger
motor
assembly
at
the
rear
of
the
stove,
and
begin
by
loosening
the
two
allen
set
screws
on
either
side
of
the
cast
iron
auger
motor
coupler.
4.
Slide
the
auger
assembly
out
of
the
tube.
5.
Next,
remove
the
four
screws
which
hold
the
cast
iron
auger
motor
coupler
to
the
auger
motor,
using
a
5/16”
wrench.
Slide
the
cast
iron
auger
motor
coupler
and
the
steel
spacer
plate
off
of
the
auger
motor.
6.
Loosen
the
allen
set
screw
which
holds
the
steel
auger
coupler
to
the
auger
motor
output
shaft,
and
remove
the
steel
auger
coupler,
as
well
as
the
rubber
vibration
dampener.
7.
Reinstall
the
parts
in
reverse
order
on
the
new
auger
motor,
being
careful
not
to
over
‐
tighten
the
bolts
which
hold
the
cast
iron
auger
coupler
to
the
auger
motor.