England's Stove Works 25PAH, Installation & Operation Manual, Page: 18 / 92

18
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR
DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.

The fuel feed rate and combustion air during start ‐ up is determined by the control board, so
the stove may be started on any heat range.

After approximately fifteen minutes, the fire should be burning brightly and the “ S U ”
should disappear from the control board. At this point, the stove has begun normal
operation and the display windows on the control board will remain empty, unless the Heat
Range or Blower Speed is adjusted.
Daily Operation Notes

Only high quality, ¼” (.25 in.) diameter wood pellets, should be used in this stove. Using low
grade wood pellets with high ash content OR wood pellets with a high moisture content
can cause the burnpot to fill with ash at a more rapid pace and can cause intervals between
periodic maintenance to become significantly shorter. Please read the “Maintenance”
section of this manual thoroughly to understand how fuel selection affects stove operation,
maintenance and cleaning.

Variation in the flame height is normal; not all wood pellet fuel is uniform in size, which can
affect the way pellets are fed into the burnpot. Although the flame height may increase and
decrease during operation, there is no loss of efficiency.

Always store wood pellet fuel in a dry location; storing wood pellet fuel in a dry location
ensures the fuel will remain pelletized and low in moisture content. Also, be certain that all
wood pellet fuel is stored at a safe distance from the pellet heater; storing fuel in close
proximity to the stove can result in a fire.

This pellet burning room heater is equipped with a specially designed burnpot which comes
preinstalled from the factory. This burnpot elevates the burning pellets and delivers air at
the precise required locations. Pellets must only be burned in the factory burnpot; no
modifications should be made to this burnpot and no additional grates or other fire
elevators should be added.

CAUTION
NEVER USE GASOLINE, GASOLINE ‐ TYPE LANTERN FUEL, KEROSENE, CHARCOAL LIGHTER
FLUID, OR SIMILAR LIQUIDS TO START OR “FRESHEN UP” A FIRE IN THIS HEATER. KEEP ALL
SUCH LIQUIDS WELL AWAY FROM THE HEATER WHILE IN USE. ADDITIONALLY, NEVER
APPLY FIRE ‐ STARTER TO ANY HOT SURFACE OR EMBERS IN THE STOVE.
DO NOT USE CHEMICALS OR FLUIDS TO START THE FIRE.
DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS SUCH AS GASOLINE, NAPHTHA OR
ENGINE OIL.