Eng3 NanoVi, User Manual, Page: 19 / 33

19
Programming User Cards
The Owner Card is used to program minutes onto the User Cards or delete
minutes from the User Card. The Owner Card, the User Card, and the
device must have the same ID#.
The maximum number of minutes a User Card can be programmed to is
9,999 minutes. The User Card can be programmed or reprogrammed as
often as required.
Insert the Owner Card. The first “Administration”-Screen will appear, the
“Mode setting”-Screen (Fig. 8.14).
Press the Page down button to go to the second “Administration”-Screen,
the
“Switch to User Card”-Screen (Fig. 8.15).
The screen shows the input keypad and the User Card Request Indicator
prompting you to enter a User Card.
If the User Card ID #, which is printed on the User Card, is not identical
with the device ID#, the "Invalid User Card"-Screen (Fig. 8.15.1) will show.
Remove Owner Card and insert a valid User Card. This will bring up the
third
“Administration”-Screen which is the “Programming”-Screen (Fig.
8.16).
The screen shows the input keypad with a
“C” button to clear an entry and the “-“ or “+“ button. Pressing the
Transfer button toggles
between adding or subtracting minutes to the User Card. The toggle status of the transfer is shown below the display of the
“
Total
Number of Minutes on User Card
”.
The top display shows the
“Total Number of Minutes on User Card”,
before transfer, on the inserted User Card. With the keypad,
choose the “ Number of Minutes to Transfer”
, by adding or subtracting
to the “
Total Number of minutes on User Card
”.
The display on the bottom shows the “
New Total Number of minutes that will be on the User Cards, after the Transfer button is pressed.
After pressing the
Transfer button, the transfer is initiated, and the top display sh
ows the updated “
Total Number of Minutes on the User
Card
”.
When the transfer is complete
, the “ Number of Minutes to Transfer”
is kept for repeat programming in the display. The bottom display
shows the “
New Total Number of
minutes on User Card”, if the
Transfer Button was pressed.
After removing the programmed User Card, the screen changes back to the
“Switch to User Card”-Screen (Fig. 8.15).
For repeat programming, the next User Card can be inserted. If the
“ Number of Minutes to Transfer”
is kept, the same number of minutes
can be transferred to the next User Card right away. To change the minutes,
the “C” button is used to clear the previous entry for new
keypad input.
After programming the last User Card press the “Page up” button until one of the three Start Screens: for
Standard-Mode (Fig. 7.2), for
Infinity-Mode
(Fig. 8.4) or the “User Card Request”-Screen (Fig. 8.7) for the
User Card Modes .
Fig. 8.14: “Mode Setting”-Screen with Owner Card
(for reference only; identical to Fig. 8.1)
Page down button goes to
“Programing”-Screen
Symbol: User Card Request Indicator
Fig. 8.15:
“Switch to User Card”
-Screen
Display shows the “
Total Number of
Minutes on User Card
”
, before transfer
Status indicator shows whether
minutes are added or subtracted
Displays the “
Number of Minutes to Transfe
r”,
add or subtract, to the User Card
Transfer button to initiate the programming process
“Page up”
button
Displays ”
New Total Number of Minutes on
User Card,
” after pressing
Transfer button
Toggle button to add or
subtract minutes
Fig. 8.16:
“Programming”-Screen
Fig. 8.15.1: “Invalid User Card"-
Screen (for reference
only; identical to Fig.
8.11.1)