Eng3 NanoVi, User Manual, Page: 13 / 33

13
The default light setting is blue. This can be changed to a different color or to a transition of colors. The device keeps running while you are
in the
“Color Selection”-Screen” (Fig 6.4) so you can see the effect of any changes before leaving the screen. The Screen shows the color
options available. Touch a circle to select a color. Pressing the white circle eliminates the color but leaves the water illuminated.
The
Brightness Level is adjusted by pressing the Sun or the Moon symbol. To turn the lights off, press the Moon symbol until the illumination
disappears. The orange Brightness Level bar will be all the way to the left.
Start the
Color Transition (rotation) by pressing any part of the Color Transition bar.
The color transition speed is selected by pressing the Slow Wave or Fast Wave symbol.
Stop the colors from changing by pressing any individual color circle.
Once you have selected your preferences, press the Check Mark button near the middle of the screen (Fig. 6.9). This saves the settings and
takes you to the
“Start“-Screen to start your session.
Session Running
When a session is started you will hear a quiet humming sound, see bubbles in the glass container, and, if the lights are turned on, see the
illumination of the water in the glass container.
If the water is bubbling, the device is operating correctly. If it is not bubbling, check to make sure the humidifier is correctly seated in the back
of the device and that the glass container is firmly screwed into the glass container holder. Correctly seating the humidifier also minimizes
the noise.
7
Operating without Smartcards: Standard-Mode only
Once the device is turned on, the initial “Splash”-Screen (Fig. 7.1) appears. A self-test runs for 10 seconds with progress shown by the bar at
the bottom of the screen.
Upon completion of the self-test, the
“Start”-Screen (Fig. 7.2) appears allowing you to enter the number of minutes for the session time.
Enter the desired session time by touching the appropriate numbers on the touch screen. The minutes are shown in the session time display
in the center of the screen.
Touching the “C” clears a number that has been entered, allowing you to change your input. The “M” on the “Start”-Screen” lets you save the
session time in the memory of the device as the default session time for future sessions, unless changed again.
Once the session time is entered, touch the blue start button to begin the session.
All the NanoVi
®
Wellness devices can be operated without SmartCards. This operation is called Standard-Mode .
In
Standard-Mode everyone has access to sessions of any duration.
Brightness Level bar
Check Mark button
No Color
(White)
Color Transition bar
Fig. 6.4
: “Color Selection”-Screen
Slow Wave and Fast Wave
for speed selection
Moon and Sun
for brightness selection
Fig.
7.1: “Splash”-Screen