
10
Set Up
There are no special tools or materials required for setup other than distilled, purified or osmotic water to clean and fill the glass container.
The user who receives treatment is the USER and when they also operate the device, they are considered the OPERATOR and SERVICE
PERSONEL.
Do not connect or attach any item that is not specified as an attachment by the manufacturer.
This product is not meant to be used in temperatures below 59°F (15°C) or temperatures exceeding 104°F (40°C).
Follow these steps to set up your device:
1.
Use indoors, away from wet/splash/drips, between 59°F (15°C) to 104°F (40°C).
2. Place the NanoVi
®
Wellness device on a clean, solid surface.
3.
Rinse glass container using distilled, purified or osmotic water.
4.
Fill the container with distilled, purified or osmotic water. Make sure the water is between the maximum and minimum filling levels
on the container.
Fill water at least to the minimum filling level as indicated on the container. Adequate air humidification depends on the amount of available
water. (Figure 5.1)
Do not fill the container with more water than the maximum filling level indicates, as water drops or water may enter the tube system or
device. (Figure 5.2)
5.
Screw the glass container into the glass container holder by hand.
6.
Insert humidifier into the fitting on the top of the device, at the back. The connecting tubes protruding from the humidifier slide
down into the device as shown in Figure 5.3.
Fig. 5.1: Correct water levels
(between min and max)
Wrong water level
because it is above
the maximum line.
This would cause
water to come out
of the FlexArm.
Correct water level,
between minimum
and maximum lines.
Fig. 5.2: Incorrect water levels
(not between min and max)
Fig. 5.3: Inserting humidifier into the device
Summary of Contents for NanoVi
